Reset camera

• Hold down the WPS button, located on the back of the camera, for 15 seconds. LED will quickly alternate between flashing red and green.

WPS mode

• Hold down the WPS button for 3-5 seconds, or until the LED starts flashing blue.

Wireless access point mode

• Hold down the WPS button for 5-7 seconds, or until the LED starts flashing white. Camera will also be in access point mode on boot, after a factory reset.

From a computer/phone/tablet

• Make sure you’ve selected the correct Wi-Fi network from your computer/ phone/ tablet.
• If you don’t see the Wi-Fi name, confirm that the camera is in Wi-Fi access point mode and that the LED on the back of the camera is flashing white. If it’s not flashing white, hold down the WPS button for 5-7 seconds. If you still don’t see the Wi-Fi name, try turning Wi-Fi mode off and then on again on your device.
• If you’re on the correct SSID but nothing comes up when connecting to http://ADCsetup, try connecting to http://192.168.1.1

From a phone/tablet with cellular connection

• See steps above.
• The camera’s Wi-Fi does not provide internet access and the device may automatically disconnect when no data connection is detected. To avoid issues, you may need to:
  • Turn off cellular data
  • Turn off phone’s automatic Wi-Fi reconnection feature
  • Move the device as close to the camera as possible

• If the wireless information was successfully added via Wi-Fi access point mode, power cycle the camera and try again.
• If the reboot doesn’t resolve the connection, factory reset the camera and try again with either the WPS or Wi-Fi access point connection methods.

1. Press the WPS button for 3-5 seconds, or until the LED begins flashing blue
2. Press the WPS button on the router
3. Wait about 2 minutes for the wireless settings to be transferred and the camera to connect to the network

Note: If the first attempt fails, it’s worth retrying. However, some routers may have the WPS disabled by default even if the button is present on the unit. So, you may need to use Wi-Fi access point mode set-up if WPS isn’t working.

1. Connect the camera’s AC adapter and plug it into a non-switched outlet.
2. Wait for camera’s LED to begin flashing white.
3. From a computer, smartphone, or tablet connect to the Wi-Fi network named “ALARM (##:##:##).” The numbers in parentheses will be last 6 digits of camera’s MAC.
4. From a web browser, type in “http://ADCsetup” and press the Enter key.
5. This should direct you to the camera’s internal configuration website. Follow the on-screen instructions to connect the camera onto a wireless network.
6. Wait for the camera’s LED to turn solid green. From a computer on the same network as the camera, log into the customer’s account at www.alarm.com/login.
7. Type www.alarm.com/addcamera into the web browser’s address bar and follow the on-screen instructions to add the camera to the Alarm.com account.

Note: Make sure to type in http://ADCsetup and press the Enter key each time you attempt to learn-in the wireless settings. Using a cached version of the page may not work.